Handspring 90 - Manual (Page 143)

Chapter 7 Page 143
3. Tap the command you want from the Command list. If the command requires additional
information, a field appears to the right of it for you to enter the information. The following
commands are available:
4. Repeat steps 2 and 3 until the login script is complete.
5. Hold Option and press Return to finish.
Wait For Tells your handheld to wait for specific characters from the TCP/IP server
before executing the next command.
Wait For
Prompt Detects a challenge-response prompt from the server and displays a
dynamically generated challenge value. When you enter the challenge value
into your token card, this generates a response value for you to enter on your
handheld. This command takes two arguments, separated by a vertical bar (|)
on the input line.
Send Transmits specific characters to the TCP/IP server to which you are
connecting.
Send CR Transmits a carriage return or LF character to the TCP/IP server to which you
are connecting.
Send User ID Transmits the User ID information entered in the User ID field of the Network
Preferences screen.
Send
Password Transmits the password entered in the Password field of the Network
Preferences screen. If you did not enter a password, this command prompts
you to enter one. The Password command is usually followed by a Send CR
command.
Delay Tells your handheld to wait a specific number of seconds before executing
the next command in the login script.
Get IP Reads an IP address and uses it as the IP address for your handheld. This
command is used with SLIP connections.
Prompt Opens a dialog box and prompts you to enter text of some kind (for example,
a password or a security code).
End Identifies the last line in the login script.
Tap here