haier HWM70-A - Manual (Page 3)

Safety precautions
Before using Before using Before using Before using
In normal usage of the washing machine,
the power plug shall be ready to be pulled
or plugged with hand. Be sure to pull the
plug off and close the water faucet in
following cases: power failure, delivering
the machine, setting the machine idle or
c l e a n i n g t h e m a c h i n e . D o n o t p l u g
or pull the power plug with wet hand.
In case the washing machine is installed on
ground with carpet, be careful not to block the
ventilation hole with carpet.
Do not let the machine share one receptacle with other
electric appliances. If the power plug is damaged, or the
plugging into the receptacle is loose, do not use it any
more.
Do not set the machine at damp place
like the bathroom. Never wash it with water.
Do not put wet laundries on the control
panel coating.
Do not use water with temperature
higher than 50
inside the tub.
Do not wash water-proof laundries like
the raincoat, bike covers, down textiles etc.
to avoid abnormal vibrations in spinning and
damaging the laundries.
Do not bend, stretch, twist, bind the power cord by force,
or reform it. Do not press or clamp it with heavy items. If the
power cord and power plug are bad, or the receptacle is loose,
be sure to have it replaced by the technicians of our special shop
or our agent, or the after-sale service department for the sake
of avoiding any risk. Keep the prong of the power plug clean.
If dust is found on the power plug, please wipe it off with dry cloth.
The ventilation
holes at the
bottom
Please insert the power cord into special
receptacle with rated voltage.Be sure to
use single-phase three pins receptacle.
The earthing terminal must be earthed
reliably.If possible,please adopt electric
leakage protector.
Earth