haier HWM70-A - Manual (Page 7)

Install the water inlet pipe
Connection between the water inlet hose jointer and the water faucet
5
Water faucet, suitable water faucet, not suitable
It is required that the front end shall be longer than 10mm.
The outlet end surface of the faucet shall be flat and smooth. If not, please file it smooth to avoid leakage.
2 Loosen the four screws of the water inlet hose jointer till the water faucet can be accessed. Then set the water inlet hose
jointer on the faucet. See to Figure 2. If the faucet is too large and the jointer cannot be set on, please loosen the four
screws and take out the bush inside the jointer. See to Figure 3.
1. Press the lower end of the lock lever and push down the slider. Take off the water inlet hose jointer from the
water inlet hose component. See to Figure 1.
3 Fasten the four screws of the water inlet hose jointer evenly. See to Figure 4.
About 4mm after twisting
Remark: .Before installation, the threading is 4mm above the upper surface of the nut.
After installation, the threading is 2mm above the upper surface of the nut..
About above 2mm after twisting
Water inlet hose jointer
Screw knife
Screw
Bushing
Nameplate
Screw nut
Water inlet hose Figure 1
Figure 4
Figure 2
Figure 5
Figure 3
Figure 6
Slider
Lock level
Before Using Before Using
Install the water inlet hose
4 Take off the nameplate. Twist the fastening nut as per the indication of the figure
to seal up the exit end face of the faucet. See to Figure 5.
Connection between the water inlet hose and the washing machine
1 Do not take off the water absorption cushion. Please check
if the cushion is dropped or damaged each time before using.
If it happens so, please duly contact our after-sale service
department.
2 Set the nut of the water inlet hose on the water inlet valve jointer.
3 Fasten the nut. Swing it gently to confirm if it's fastened well.
Water absorption cushion.
Water inlet
hose nut
Water inlet valve jointer