Harbor Freight Tools 99741 - Manual (Page 6)

For technical questions, please call 1-800-444-3353;
troubleshooting section at end of manual.
SKU 99741 PAGE 6
Plug in a dry location and as far away
as possible from the object being
sprayed. Keep all electrical connec-
tions dry and off the ground.
When using the Pressure Washer, al-
7.
ways maintain a firm grip on the Wa-
ter Gun with both hands. Squeezing
the Trigger of the Water Gun causes
a kickback force.
Do not pull or carry the Power Wash-
8.
er by its Power Cord, or pull the Cord
around sharp corners or edges. Do
not unplug the Power Washer by pull-
ing on the Cord. Keep the Cord away
from heated surfaces.
Do not handle the GFCI Plug with wet
9.
hands.
Avoid unintentional starting. Make
10.
sure you are prepared to begin work
before turning on the Pressure Wash-
er.
The work area should have adequate
11.
drainage to reduce the possibility of a
fall due to slippery surfaces.
This Pressure Washer is intended for
12.
outdoor residential use only.
Some chemicals or detergents may
13.
be harmful if inhaled or ingested.
Use an ANSI approved respirator or
mask whenever there is a chance
that vapors may be inhaled.
Keep the High Pressure Hose con-
14.
nected to the Pressure Washer and
Spray Gun while the system is pres-
surized. Disconnecting the Pressure
Hose while the unit is pressurized is
dangerous, and may cause injury.
Prior to starting the Pressure Washer
15.
in cold weather, check all of the parts
of the unit to make sure ice has not
formed. Do not store the unit any-
where that the temperature will fall
below 32° F (0° C). (See “Inspection,
Maintenance, and Cleaning” section
for proper storage procedures.)
Do not feed already-pressurized wa-
16.
ter (Such as that from another pres-
sure washer) into this washer.
When dispensing detergent, apply
17.
the detergent to the cleaning area at
low pressure only. Then, spray the
detergent off the cleaning area by us-
ing the adjustable Nozzle. NOTICE:
Detergent dispensing only works
when the spray wand is in the low-
pressure position.
The high pressure water flow can
18.
damage the work surface if not used
properly. Always test the spray in an
open area first.
Never move the Pressure Washer by
19.
pulling on the High Pressure Hose.
Use the Handle provided on the top
of the unit.
Never leave the Pressure Washer
20.
unattended when it is plugged into an
electrical outlet. Turn off the Pres-
sure Washer, and unplug it from its
electrical outlet before leaving.
If water is leaking out of the Pressure
21.
Washer immediately shut off the unit.
Unplug the Pressure Washer, and
discharge all pressure before tighten-
ing fittings or having repair work done
by a qualified technician.
People with pacemakers should
22.
consult their physician(s) before use.
Electromagnetic fields in close prox-
imity to heart pacemaker could cause