Harbor Freight Tools TORCH KIT 94903 - Manual (Page 5)

SKU 94903 For technical questions please call 1-800-444-3353 Page 5
operATion
igniting and extinguishing The Torch:
To ignite the torch push the Gas “On/Off” Switch forward towards the tip until the
Gas “On” Lock button pops out. This will lock the Gas “On/Off” switch in the “On”
position.
Next push the “Piezo Igniter” button forward repeatedly until the torch is lit.
To turn off the torch, push the Gas “On” Lock button. By doing this the Gas “On/Off “
switch will slide to the off position and extinguish the flame. If the flame continues to
burn, press the “Flame Off Button”.
Allow the tool to cool down before setting it down. Only set the tool down after the
stand has been opened. See page 7 for instructions regarding this.
WARNING: never leave the tool unattended while in operation or while hot. Serious
personal injury and risk of fire may result.
Setting up the Soldering iron:
The Torch comes with the “Soldering Iron Adapter” already installed. It is the longer
of the two adapters and has a threaded end that receives the soldering tips.
If you do need to install “Soldering Iron Adapter”, first remove the “Adapter Lock
Nut” then slide the “Soldering Iron Adapter” over the ceramic insulator, then thread
on the “Adapter Lock Nut”.
Pick the desired tip from the kit and screw it onto the end of the “Soldering Iron
Adapter”.
1.
2.
3.
4.
1.
2.
3.
Soldering Iron Stand
Soldering Iron Adapter
Piezo Igniter
Adapter Lock Nut
Gas “ON” Lock Button
Gas “ON” Lock Switch
REV 07j