HP 9100 series - Manual (Page 23)

ENWW Installing the HP Jetdirect print server 21
Installing the internal print server
CAUTION The HP Jetdirect print server card contains electronic components that can be damaged by
static electricity. To prevent the buildup of static electricity, maintain frequent contact with any
bare sheet-metal surface on the all-in-one. If possible, wear a grounding wrist strap (or similar
device). Handle the print server card carefully at all times. Avoid touching electronic
components or circuit paths. Failure to follow these recommendations could result in damage
to the parts.
To install the internal print server
1 Press (P OWER ) to turn off the all-in-one.
2 Unplug the power cord and disconnect any cables.
3 Use a Phillips screwdriver to loosen and remove the two retaining screws that hold the
cover for the empty EIO slot. Remove the cover.
4 Firmly insert the HP Jetdirect print server card into the EIO slot.
5 Insert and tighten the retaining screws that came with the HP Jetdirect print server card.
6 Connect a network cable between the HP Jetdirect print server card and the network.
To verify that the print server has been installed correctly
1 Connect the power cord and press (P OWER ) to turn on the all-in-one.
2 Print a Configuration page (see Configuration page ).
Two pages should print. The second page is the HP Jetdirect Configuration page, which
contains setup information (for example, LAN HW ADDRESS) that might be needed when
you set up the all-in-one on the network computers.
If the HP Jetdirect Configuration page does not print, uninstall and reinstall the print server
card to ensure that it is completely seated in the slot.