Loading an original on the scanner glass – HP 9100 series User Manual
Page 40
38 3 - Using the all-in-one
ENWW
Loading an original on the scanner glass
You can copy or scan any original by placing it on the scanner glass.
Note
Some all-in-one options will not work correctly if the scanner glass an ADF lid backing are not
clean. See
for more information.
To load a document on the scanner glass
1
Make sure that no originals are loaded in the ADF.
2
Lift the ADF.
3
Place the original face-down on the scanner glass in the corner shown in the following
illustration. The sides of the original should touch the right and front edges.
It is important to place the original as shown. Otherwise, part of the original might be
clipped in the resulting scan.
Note
If you are copying from a transparency (that is, your original is printed on transparency film),
place a blank piece of paper between the transparency and the flatbed scanner lid.
4
Close the ADF.
CAUTION
To prevent damaging the all-in-one, do not allow the scanner lid to fall onto the flatbed scanner
surface.
Always close the ADF when the all-in-one is not in use.