HP 9100 series User Manual
Page 74
72 6 - Sending scans
ENWW
The file name might be preconfigured. To temporarily change the file name, use the control
panel or keyboard. To restore the default setting, press R
ESET
. For information about setting
the default settings, see
Setting defaults for all scan jobs
To send a scan to a network folder
1
Load the original on the scanner glass or in the ADF. See
for more
information.
2
If required, type your PIN on the keypad or keyboard.
3
Press S
CAN
.
4
With the cursor next to
<HOST\Sharename>
, press
(select).
5
Specify the destination by doing one of the following:
• Type the pathname for a network folder on the keypad or keyboard.
• Press a speed-dial button, if speed-dial entries have been set up for network folders.
6
To set scan options, use one of the following methods:
• Press a control-panel option button (for example, Q
UALITY
), select the value, and then
press (select).
• Select an option from the control-panel display (for example,
Lighter/darker
), select
the value, and then press
(select).
7
Press S
TART
.
The connection might take some time.
8
If prompted, type your user name, and then press
(select).
9
If prompted, type your password, and then press
(select).
Sending scans to a program on a computer (direct
connection)
Use the following steps if your all-in-one is directly connected to a computer by means of a
USB or parallel cable.
When the scan is complete, the program that you have selected opens and displays the
document that you have scanned.
The scan procedure saves the document in a folder named My Scans.
To send a scan to a program on a computer from the HP photo and
imaging software
1
At the computer, open the HP photo and imaging software. See
for more information.
2
See the onscreen Help for further instructions.
To send a scan to a program on a computer from the control panel
1
Load the original on the scanner glass or in the ADF. See
for more
information.
2
If required, type your PIN on the keypad or keyboard.
3
Press S
CAN
.