Havis-Shields 2000-2005 Chevrolet Impala Trak-Mount Kit C-TM-IMP - Manual (Page 2)

C-TM-IMP-INST-2-07 2
INSTALLATION:
1. REMOVE SEATS:
• Remove rear seat base torx bolts.
• Slide seat to rear most position.
• Seats do not have to come out of vehicle, they will just need to be tilted out of way to
place Trak-Mount assembly. Be careful of wire plugs if vehicle has power seats.
2. MOUNT ASSEMBLED TRAK-MOUNT:
• Place Trak-Mount assembly so front bracket sets squarely on floor beam straddling
seat bolts – lag bolt to the floor beam. The rear hump brackets are place on floor
between floor of vehicle and seat base and can be mounted using the rear seat bolts.
• Re-mount seats over Trak-Mount assembly and tighten all hardware.
• Mount equipment (consoles, control heads, etc), prior to plastic end caps, for access
to hardware slots.
Rear Hump Bracket
(Driver Side)
Rear Hump Bracket
(Pass. Side)
Front Hump Bracket
Trak