HP LC3700N - Manual (Page 25)

Setting Up
Setting Up 15
Removing CableCARD
1 Turn on the TV; see “Turning the TV On and Off
(Standby)” on page 27.
2 Check that the CableCARD upgrade screen is not
displayed. If it is displayed, wait until it
disappears.
3 Check that the OPC light on the front of the TV is
NOT red; see “Turning the TV On and Off
(Standby)” on page 27. If it is red, wait for the
OPC light to change or go out.
4 Remove the CableCARD.
Disconnecting the cable antenna when
using CableCARD
1 Turn on the TV; see “Turning the TV On and Off
(Standby)” on page 27.
2 Check that the CableCARD upgrade screen is not
displayed. If it is displayed, wait until it
disappears.
3 Check that the OPC light on the front of the TV is
NOT red. If it is, wait for it to change or go out.
4 Disconnect the cable antenna.
For more information about CableCARD, refer to
“Using the CableCARD Menu” on page 62.
Connecting cable or satellite with a set-top box
Connecting your TV directly to the audio and video
output of your set-top box assures a more vivid picture
and enhances your viewing enjoyment.
Optional equipment and all cables are sold separately.
You can connect a digital TV set-top box (air or cable)
and other audiovisual equipment by using:
■ Input 1 terminals with either component or
composite video connections
■ Input 2 terminals with either component or
composite video connections
■ Input 4 terminals with HDMI connection
■ Input 5 terminals with DVI connections
1 Connect the set-top box input source cable(s) to
the back of the TV using one of the terminals sets.
■ Input 1 (A) or Input 2 (E) using component
connections. (Input 1 shown.)
n
If your cable TV company has CableCARD
available, you can also use the CableCARD
to receive HDTV programs. See “Using a
CableCARD” on page 13.
c
CAUTION: Unplug power for the TV and all
connected components before connecting
the set-top box.
C
E
A
B
D