HP LC3700N - Manual (Page 39)

Using the First-Time Setup Wizard
Using the First-Time Setup Wizard 29
Using the First-Time Setup Wizard
Initial Setup
When turning on the TV for the first time, it
automatically memorizes the broadcasting channels
where you live. Perform the following steps before you
press TV Power on the remote control unit.
1 Insert the batteries into the remote control unit.
2 Connect the antenna cable to the TV.
3 Plug in the AC cord to the AC outlet.
Language setting
1 Select from among three languages: English,
French, and Spanish.
2 Press the up arrow and down arrow buttons on the
remote control to select the desired language
listed on the screen, and then press Select.
Standby mode setting
Select the standby mode setting.
■ Mode 1: Starting TV is quick from standby.
■ Mode 2: Power consumption is small when in
standby.
Antenna setting
1 Press the left arrow and right arrow buttons on the
remote control to select Air or Cable for analog.
Then press the down arrow button to move down.
2 Press the left arrow and right arrow buttons to
select Standard, HRC, or IRC for digital (cable).
3 Press Select to enter the setting.
■ This operation makes the TV search for both
analog and digital (cable).
■ There are three types of CATV systems,
including Standard, HRC, and IRC. Select the
one that matches your TV.
Channel search
Channel search automatically searches for a signal
from all channels in the area.
1 Press the left arrow and right arrow buttons on the
remote control to select Yes or No for Analog,
and then press the down button to move down.
Language
Standby Mode
Air/Cable
CH Search
Mode 1
Mode 2
n
When the CableCARD is inserted, power
consumption is higher.
n
Digital (cable) setting cannot be selected
when a proper CableCARD is inserted.