Hitachi DZ-MV350A - Manual (Page 56)

56
E
nglis
h
QR34962
MACRO RECORDING
Use the macro function when recording a small object from close-up position: You can shoot the subject
as close as approximately 13/16” (2 cm) from the lens surface, magnifying the image to fill the screen.
1
Aim the DVD video camera/recorder at the
subject, and press down the zoom lever to “W”
control side. Note :
• Zoom can be used, but the subject may not be focused,
depending on the distance to the subject. In this case,
move the zoom to “W” control side to focus.
• The amount of light tends to be insufficient during macro
recording: If the subject image is too dark, use additional
lighting.
RECORDING SUBJECTS FOR STRONGER WIDE-ANGLE OR TELEPHOTO
EFFECT
Use tele-conversion lens or wide-conversion lens to record subjects for stronger telephoto or wide-angle
effect.
Use conversion lenses with the following filter diameters:
DZ-MV350A: 30.5 mm
DZ-MV380A: 37 mm
1
Remove the lens hood from DVD video camera/
recorder.
2
Remove the cap of conversion lens, and screw
the lens into the filter thread of DVD video
camera/recorder until it stops.
* With DZ-MV380A, you can use the optional conversion lenses:
• Tele-conversion lens (DZ-TL1): For stronger telephoto effect
• Wide-conversion lens (DZ-WL1): For stronger wide-angle effect
Note :
• Be careful not to lose the removed lens hood.
• With DZ-TL1 tele-conversion lens, the focusing range at
“T” (telephoto) control side is between approx. 5 m and
infinite.
• When a conversion lens is attached, note that if you zoom
in on a subject, vignetting will slightly occur on the “W”
(wide-angle) control side (the four corners of screen will
be dim).