HONDA Quicksilver 54 - Manual (Page 10)

OPTIONAL 30-0028 PUSH TUBE ASSEMBLY
1. If you have purchased the optional 30-0028 lawn mower push tube assembly,
assemble it at this time as per the instructions enclosed in that package. NOTE:
The pivot in that kit is installed on the push tube assembly UPSIDE DOWN FOR
PACKAGING PURPOSES. Remove it and reinstall it as shown in the drawing
below.
2. Attach the pivot/push tube assembly to the Quicksilver 54 frame as show above.
3. Attach the push tube assembly to the push tube attaching brackets on the ATV,
using the 3/8” x 1” clevis pins and #3 hairpins included with the attaching bracket
kit.
WIRING AND CONTROLS
1. WIRE ATTACHMENT. Using a wire tie or electrical tape, attach the ATV
wiring harness to the front of the ATV brush guard so that the gray connector
hangs free about 4” out from the front of the ATV. Route the Red (+) positive
cable along the frame of the ATV to the battery, using care to route it away from
exhaust system and areas where it might chafe or burn. Use the most direct route.
Cut off the excess cable. Attach the ring terminal eyelet connector to the end of
the cable and attach to the positive (+) terminal of the battery. Secure wire along
the frame using wire ties or electrical tape. Attach the Black (-) negative ground
cable at the nearest ground point on the ATV. (Example: a front bumper frame
bolt.) Connect the gray ATV wiring harness to the gray mower wiring harness.
10