Table 2-1. accessories in figure 2-1 – HP 8517B User Manual
Page 33
HP 8517B S-Parameter Test Set Manual 2-3
Installation
Initial Inspection
Figure 2-1
Accessories Supplied with the HP 8517B Test Set
CAUTION
Assemblies in the test set are extremely sensitive to damage by static
electricity. They may or may not continue to function if subjected to an
electrostatic discharge. Their reliability, however, will be impaired.
CAUTION
Always use an anti-static wrist strap when calibrating or verifying the test set
or while using the test set to measure devices. Never touch test port center
conductors. Use a wrist strap when connecting the extended center
conductor of a sliding load termination.
Table 2-1
Accessories in Figure 2-1
(1) Power Cord U.S.A. only
(6) Female 2.4 mm to Female 2.4 mm Adapter
(2) Test Set Interconnect Cable
(7) 20 mm, 98 N-cm (8 in-lb) Torque Wrench
(3) HP-IB Cable
(8) 1/2” x 9/16” Open End Wrench
(4) Specification and Performance Verification Software
(9) RF Source Cable, Bench-top Configuration
(5) Anti-rotation Clamps
(10) RF Source Cable, Rack Configuration