Hunter Fan 32200 - Manual (Page 6)

43001-01 04/27/2007 6 © 2007 Hunter Fan Co.
Cleaning The Humidifier and The Water Tank
Refilling The Water Tank
1. When the water tank level is low, turn the humidifier ‘oFF’, and unplug.
2. Remove the tank and take it to the sink or tub to refill.
3. Turn the tank upside down and unscrew the tank cap by turning it counterclockwise. Empty the tank,
refill with fresh cool water (never use hot water), and replace the tank cap. Be sure not to overfill the
tank as water damage may occur to furniture or flooring due to spillage. HuNTER WILL NoT aCCEpT
RESpoNSIBILITY FoR daMaGE To pRopERTY CauSEd BY WaTER SpILLaGE.
4. Carry the tank back to the humidifier. Turn the tank upright and place it on the humidifier. Be sure
that the tank is seated properly in the base. If the tank is properly located on the base, you will
see air bubbles flowing up into the tank.
Many regions have hard water with high concentrations of minerals. When water evaporates from The
Hunter® Evaporative Humidifier, minerals may be left behind. These minerals can form a hard white
scale which can be removed by following the cleaning instructions. The frequency of cleaning due
to mineral build up can vary depending upon the quality of water you may have.
Refer to Figure 1 for part names.
1. Turn the humidifier ‘oFF’ and unplug the unit.
2. Lift the main housing and remove the water dispersion tray and the wick. The motor is attached
to the main housing. do not place the motor near water. do not use a wet towel on the motor or
motor housing as electrical shock may occur.
3. Replace the humidifier’s wick every 4 - 8 weeks or when it has turned brown.
4. Remove the water tank from the base and empty any water that is left in the tank. Soak the base
in a mixture of one (1) gallon of water and eight (8) ounces of vinegar for 20 minutes. The base is
dishwasher safe.
5. after soaking, wipe the base with a soft cloth or sponge to remove any mineral build up. Rinse
with clean water several times. If you are planning on storing the humidifier, be sure the base
is completely dry.
6. Fill the water tank with one (1) gallon of water and eight ounces of undiluted white vinegar. Re-
place the tank cap and shake the tank vigorously until all interior surfaces of the tank have been
exposed to the water/vinegar mixture.
7. Empty the tank of the water/vinegar mixture. Rinse it several times with clean water and then
replace the tank cap. If you are planning on storing the humidifier, dry it inside and out, leaving
the cap off to allow the tank to completely dry. Continue to clean the other parts of your humidi-
fier.
8. Wipe the surfaces of the main housing with a soft cloth.
9. once all the parts are clean, reassemble the humidifier, and follow the uSING YouR
HuMIdIFIER to continue use. If you are storing the humidifier, make sure the parts are completely
dry, reassemble, and store in a dry location.