Hoover Shampoo- Polisher - Manual (Page 20)

If you have a problem
The appliance was inspected thoroughly and was in good operating con-
dition when it was shipped from the factory. If a minor problem occurs it
usually can be solved quite easily when the cause is found. Therefore,
this check list is provided for your convenience.
Problem Possible cause Possible solution
Unit won’t 1. Not firmly plugged in. 1. Plug unit in firmly.
run 2. No voltage in wall plug. 2. Check fuse or breaker.
3. Blown fuse/tripped 3. Replace fuse/reset
breaker. breaker.
Unit won’t 1. Filter bar clogged. 1. Clean filter bar.
pick up
solution
Extreme 1. Defoaming cake needs Replace defoamer cake.
sudsing of replacing.
used solu-
tion
1. Foam generator clogged. 1. Clean foam generator.
er does
not dis-
pense
foam
Service
To obtain approved HOOVER service and genuine HOOVER parts, locate
the nearest Hoover Factory Service Center or Authorized Hoover
Warranty Service Dealer (Depot) by:
l checking the Yellow Pages under “Vacuum Cleaners
Household” OR
checking the list of Factory Service Centers provided
with this cleaner OR
l calling I-800-944-9200 for an automated referral of
authorized service outlet locations (US. only)
Do not send your cleaner to The Hoover Company in North Canton for
service, this will only result in delay.
If further assistance is needed, contact The Hoover Company Consumer
Response Center, North Canton, Ohio 44720 Phone: 330-499-9499.
In Canada, contact Hoover Canada, Burlington, Ontario
Phone: l-800-263-6376.
Always identify your cleaner by the complete model number when request-
ing information or ordering parts. (The model number appears on the
bottom of the cleaner.)
19