Hoover Shampoo- Polisher - Manual (Page 7)

The tank
The tank has one section for stor-
age of fresh cleaning solution and
one section for storage of dirty
solution that has been picked up
from the floor.
To fill tank
A. Remove tank by pressing tank
handle down and pulling tank for-
ward.
B. Lift cap marked “FILL”. Pour
premeasured cleaning solution
into opening marked “CLEAN
SOLUTION” until it reaches the
“FULL” line on the tank.
To empty tank
To empty dirty solution, remove
tank and pour from the opening
marked “USED SOLUTION”.
Rinse used solution container with
clear water. Clean solution may be
emptied by opening “FILL” cap
and pouring from the “CLEAN
SOLUTION” opening.
Attach and remove
brushes and pads
Disconnect from electric circuit
before putting on or removing
brushes.
Place shampoo-polisher upside
down on a flat surface. Press
each brush firmly down over
brush shaft, rotating brush until a
click indicates that it is in the cor-
rect position. To remove-grasp
center with thumb and fingers
and lift up brush.
6