HP PN1050 - Manual (Page 27)

ENWW TCP/IP Configuration 27
TCP/IP Other Settings
syslog-config:
Enables or disables syslog server operation on the projector server: 0 disables,
1 (default) enables.
syslog-svr:
(syslog-srv:)
The syslog server’s IP address. It specifies the server that the HP Jetdirect
projector server sends syslog messages to. For more information, see
Appendix A .
syslog-max:
Specifies the maximum number of syslog messages that can be sent by the
HP Jetdirect projector server on a per-minute basis. This setting allows
administrators to control the log file size. The default is 10 per minute. If set to zero,
the number of syslog messages is not restricted.
syslog-priority:
Controls the filtering of syslog messages sent to the syslog server. The filter
range is 0 to 8, with 0 being the most specific and 8 the most general. Only
messages that are lower than the filter level specified (or higher in priority) are
reported. The default is 8, messages of all priorities are sent. If 0, all syslog
messages are disabled.
syslog-facility:
A code used to identify the source facility of a message (for example, to identify
the source of selected messages during troubleshooting). By default, the
HP Jetdirect projector server uses local user values of local0 through local7 to
isolate individual or groups of projector servers. The default is local0.
slp-config:
Enables or disables the Service Location Protocol (SLP) operation on the projector
server: 0 disables, 1 (default) enables.
slp-keep-alive:
Specifies a time period for the projector server to send multicast packets on the
network to prevent being deleted from network device tables. Some infrastructure
devices, such as switches, may delete active devices from their device tables due
to inactivity on the network. To enable this feature, set a value from 1 to 1440
minutes. Set 0 to disable this feature.
ttl-slp:
Specifies the IP multicast “Time To Live” (TTL) setting for Service Location Protocol
(SLP) packets. The default value is 4 hops (the number of routers from the local
network). The range is 1-15. When set to a -1, multicast capability is disabled.
ipv4-multicast:
Enables or disables the receipt and transmission of IP version 4 multicast packets
by the projector server. 0 disables, 1 (default) enables.
Table 3.3 TFTP Configuration File Parameters (3 of 7)