Setting up (continued) – Hitachi CP-X1250 User Manual
Page 7
IN
TE
R
IN
PU
T
M1
-D
RG
B
BNG
S-V
ID
EO
ST
ANDBY
/O
N
TE
MP
VID
EO
CO
MP
ON
EN
T
LAM
P
KE
YS
TON
E
SEA
RCH
RE
SE
T
ME
NU
FO
CUS
LEN
S S
HIFT
ZO
OM
7
Setting Up (continued)
Setting Up (continued)
Adjusting The Projector's Elevator
Using The Lens Shift Buttons
• Generally, better quality of a picture is available when the lens shift is set
to the center.
NOTE
You can use the elevator feet to make adjustments if the surface on which you need to set
the projector is uneven or if you otherwise need to adjust the angle of projection. The
adjustment range of the elevator feet is 0 to 9 degrees.
WARNING • Do not touch about the lens and ventilation openings during use or
immediately after use to prevent a burn.
CAUTION • To prevent damaging the projector and injuring yourself, always
hold the projector whenever using the elevator buttons to adjust the elevator feet.
Press and hold in the elevator buttons.
Raise or lower the projector to the desired height and
then release the elevator buttons.
When you release the elevator buttons, the elevator
feet will lock into position.
As necessary, you can also finely adjust the height of
the projector by twisting the elevator feet by hand.
Elevator buttons
Elevator feet
The lens of this projector can be shifted
vertically. When you want to finely adjust the
picture position, use the LENS SHIFT buttons
of the projector.
10:0
1 :1
1
2
3
STANDBY/ON
VIDEO
LASER INDICATOR
RGB
BLANK
ASPECT
LASER
LENS SHIFT
+
–
–
–
+
+
FOCUS
ZOOM
Projector
LENS SHIFT buttons
Remote control
LENS SHIFT