HP 210/210LX - Manual (Page 4)

ii
Safety symbols Safety symbols Safety symbols Safety symbols Safety symbols
If present, this symbol is placed on the copier
where it is necessary for you to refer to the
manual in order to understand a hazard.
!
If present, this symbol is placed on the copier
within the area where hazardous voltage is
present. Only trained service persons should
perform work in this area.
If present, this symbol is placed on the copier
within the area where electrostatic discharge
(ESD) may occur. ESD can damage the copier’s
electronic components. Avoid touching elec-
tronic components or circuit paths. Use proper
grounding devices when circuits are open to
outside areas.
If present, this symbol is placed on the product
within the area where hot surfaces are present.
Allow the product to cool before performing
work in this area.