Hitachi 42EDT41 - Manual (Page 32)

ENGLISH
Video Unit Function
Monitor rear panel Speaker (R) Speaker (L)
Power
cord
(1) Make sure that the power switch of the monitor is turned off.
(2) Make sure that the power switch of the imaging device is turned off.
(3) Use a commercially available cable and connector to connect the signal input terminal on the rear panel of this
device and the signal output terminal of the imaging device.
INSTALLATION INSTRUCTIONS
Connecting to a Video Imaging Device
• If video equipment with an S video output terminal is used, cabling
by the S video cable is recommended to provide finer video
quality. (If the S video input terminal and the video input terminal
of AV3 connect to the monitor at the same time, S video input
would govern.)
• If the OUTPUT (MONITOR) terminal is connected to an external
monitor with a 75 Ohm terminal, it is possible to view the same
image as on the main unit. But it is possible to monitor only the
composite video signal from AV1, AV2, AV3 or AV4 input that is
displayed on the screen at the time.
• If the adaptor is applied to AV4 input as shown in the drawing, it is
impossible to receive RGB signal.
With DVI-STB and RGB component setup
To component video
equipments.
Please use the connection
cable suitable for the terminal
form of video equipment.
Applicable video signals for each input terminal (See PRODUCT SPECIFICATIONS for details. )
Terminal RCA/SCART DVI D-sub Remarks
Signal CVBS S-video Component RGB PC STB RGB Component
AV1
AV2 Refer to Setup Menu.
AV3
AV4 Refer to Setup Menu.
RGB1 Refer to Setup Menu.
RGB2 Refer to Setup Menu.
(
Use if the
video
equipment
has an
S video
input terminal
To
S video output terminal
To
audio output terminals To
audio output terminals To
component output terminals To
component output terminals To
component input terminals
To
component input terminals
To
composite input terminal
To
audio output terminals
To
audio input terminals
20 18 16 14 12 10 8 6 4 2
21 19 17 15 13 11 9 7 5 3 1
VCR
VCR
DVD player Set-Top Box
Video disc player
Adaptor
To
composite output terminal
S-video/Composite video
Do not connect both
plugs at the same time.
Use either of them.
[An example of connecting video imaging devices]