Horizon Fitness ELITE 4.2E - Manual (Page 5)

BEFORE
YOU
BEGIN
8
INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ASSEMBL
Y
BEFORE
YOU
BEGIN
ELLIPTICAL OPERA
TION
LIMITED
W
ARRANTY
TROUBLESHOOTING
&
MAINTENANCE
CONDITIONING
GUIDELINES
BEFORE YOU
BEGIN
ASSEMBL
Y
9
INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ELLIPTICAL OPERA
TION
CONDITIONING GUIDELINES
TROUBLESHOOTING &
MAINTENANCE
LIMITED WARRANTY
ASSEMBLY STEP 2
A) Open HARDWARE BAG FOR STEP 2.
B) Slide left and right FOOT LEVELERS
onto MAIN FRAME.
C) Attach FOOT LEVELERS using
WASHER (E) and BOLT (F).
��������
�����
������
���������������
�����
������
HARDWARE BAG FOR STEP 2 CONTENTS :
���������������
��������
������������
����������
���������
�������������
�����������������
������������
���������� ���������������
���������
����������
ASSEMBLY STEP 3
�����������������
�����
������
�����������������������
����������
������
�����
�������
������
���������
�����
������
HARDWARE BAG FOR STEP 3 CONTENTS :
A) Open HARDWARE BAG FOR STEP 3.
B) Slide TEFLON SHEET WASHER (G),
PEDAL ARM and TEFLON WASHER
(H) over PEDAL ARM BRACKET
C) Secure PEDAL ARM to PIVOT TUBE,
using NYLON NUT (I).
D) Attach PEDAL ARM COVER using
SCREW (J).
E) Repeat on other side.
������������
�������������
������������
����������
������������
�����
���������
���������������
���
�����
ASSEMBLY STEP 4
���������
�����
������
��������
�����
������
HARDWARE BAG FOR STEP 4 CONTENTS :
NOTE: There is NO hardware for steps
A-D. All hardware is pre-installed.
A) Remove PRE-ATTACHED BOLT &
WASHERS from CONSOLE MAST.
B) Slide LOWER HANDLEBAR onto
CONSOLE MAST and attach by re-
inserting
PRE-ATTACHED BOLT &
WASHER.
C) Slide UPPER HANDLEBAR onto
LOWER HANDLEBAR and align
NOTCH with TAB making sure
handlebars are joined together
completely. Secure
UPPER
HANDLEBAR to LOWER HANDLEBAR
using
PRE-ATTACHED SET SCREWS.
D) Repeat on other side.
WARNING
After handlebars are assembled they will rotate freely – be cautious. Until the
machine is fully assembled, do not grab the handlebars for support.
E) Open HARDWARE BAG FOR STEP 4.
F) Attach FRONT & BACK HANDLEBAR
COVERS using 2 SCREWS (K) and 2
BOLTS (L) for each side.
4.2E ONLY
���������
���������
������
���������
���������
4.2E ONLY 4.2E only
Elite 3.2E 4.2E Elliptical Rev 1.0.indd 8-9 7/13/05 2:47:56 PM