HP RP3440 - Manual (Page 21)

6 GB (HP 9000 rp3410 server), 24 GB (HP 9000 rp3440 server with 2 GB DIMMs installed
in all 12 slots), or —
— 32 GB (HP 9000 rp3440 server with 4 GB DIMMs installed in the first eight slots)
• For the HP 9000 rp3410 server, DIMMs are as follows:
— 256 MB, 512 MB, and 1 GB
— standard 184 pins 2.5V
— DDR266, CL2, registered, ECC
• For the HP 9000 rp3440 server, DIMMs are as follows:
— 256 MB, 512 MB, and 1 GB, 2 GB, 4 GB
— standard 184 pins 2.5V
— DDR266, CL2, registered, ECC
• Only one supported configuration for 4 GB DIMMs; 2 quads (8 DIMMs); and no other DIMMs
can be installed.
• DIMMs loaded by quads enable interleaved mode and chip spare.
• Memory is loaded across both memory busses (two DIMMs on each bus) to ensure maximum
bandwidth and performance.
• 133 MHz memory bus frequency, 266 MTransfers/s data, 8.5 GB/s peak data bandwidth.
• Total memory bandwidth is 8.5 GB/s, split across two 4.25 GB/s memory buses.
• Open page memory latency is 80 nanoseconds.
PCI Riser
Two (HP 9000 rp3410 server) or four (HP 9000 rp3440 server) independent PCI-X 133 MHz 64-bit
3.3V 15W slots. No 5V card and hot-pluggable support.
Internal Core I/O
The following is supported on the HP 9000 rp3410 and rp3440 servers:
• Dual-channel SCSI U160 interface, two internal 68-pin connectors, one 68-pin external
connector.
• SCSI backplane configured either as two channels with 2+1 drives. A SAF-TE accessory
(currently not available) is required to configure the SCSI backplane as one channel with
three drives.
• Three internal SCSI drive connectors are of the 80-pin type and provide drive electrical
hot-pluggable capability.
• SCSI backplane is designed to support a SCSI management piggy board accessory that
provides a SCSI management SAF-TE chip and shunts the backplane's channels A and B to
provide three disks on channel A and leave only the external connector on channel B.
• One internal IDE connector for a slim-line optical device (CD and DVD).
• No floppy connector.
External Core I/O
The following is supported on the HP 9000 rp3410 and rp3440 servers:
• One SCSI U160 68-pin connector.
• One 10/100/1000Base-T Ethernet LAN connectors for copper cable.
• Four USB 2.0 ports.
• Three DB-9 ports (console, UPS, and modem) through a 3-connector M cable.
Power Supply Unit
The following is supported on the HP 9000 rp3410 and rp3440 servers:
Detailed Server Description 21