Powering off the server manually – HP RP3440 User Manual
Page 40
3.
To enable command mode, enter CM.
4.
To use the remote power control command, enter PC.
5.
Enter OFF to power off the server, and enter YES when prompted to confirm the action.
IMPORTANT:
The main DC voltage is now removed from the system; however, AC voltage
for standby power is still present in the server.
6.
Unplug all the power cables from the receptacles on the rear panel of the server.
Powering Off the Server Manually
To manually power off the server, follow these steps:
1.
Gracefully shut down the operating system.
2.
Press the Power button to power off the server.
IMPORTANT:
The main DC voltage is now removed from the system; however, AC voltage
for standby power is still present in the server.
3.
Unplug all the power cables from the receptacles on the rear panel of the server.
40
Overview