Heath Zenith 598-1135-08 - Manual (Page 8)

8 598-1135-08
TO HOT
OR LIGHT
TO HOT
OR LIGHT
TO HOT
OR LIGHT
1
BLACK
3
BLACK
GREEN (Ground)
DIM
1
BLACK
TO HOT
OR LIGHT
4
BLACK
GREEN
(Ground)
2 RED
2
RED
3 BLACK
4 BLACK
Removing Tab In Battery Chamber
2. To remove tab from battery chamber, remove screw in access
door of remote with a small phillips-head screwdriver. Gently
pull tab out of battery chamber. Reassemble access door in
reverse order.
Tab
ON
12V
Inside of Remote Control
ON
12V
Battery
Compartment
(Type A23)
3. Push and release the ON button (left button) to turn light on or
the OFF button (right button) to turn light off. Note: Red light
on remote should come on while button is depressed.
IMpORTANT: Wait 1 to 2 seconds after you press a transmitter
button before you press it again to allow the transmission to be
completed.
Note: If light does not turn on or intermittently turns on and off when
remote buttons are pushed, see Troubleshooting Guide.
Battery Replacement
The remote control requires a type A23 12 Volt alkaline battery to
operate. The remote control is shipped with the battery installed.
With typical use, the battery will last approximately one year.
Remove battery when remote will not be used for an extended
period of time.
To replace the battery, follow the instructions below:
1. Turn remote control upside down.
2. Remove screw in access door of remote with a small phillips-
head screwdriver.
3. Remove access door and lay aside.
. Remove battery. Install replacement battery. Make sure battery
is oriented properly (see illustration).
5. Reassemble access door in reverse order.
3-waY waLL SwItCH tRaNSMIttER
Important: This product must be used in conjunction
with the Wall Switch Receiver. 3-way circuit wiring is
required to install and use this product.
Note: If you are not familiar with electrical wiring, consult
an electrician about installation. In addition, some local
building codes may require installation by a qualified electrician.
Installation
1. Select light switch to be replaced by 3-way wall switch transmit-
ter.
2. waRNING: turn off the power to the light switch circuit
before you proceed. Do this at your circuit breaker or fuse
box.
3. Remove the existing wall plate and switch. Label the wires on
the existing switch according to the diagram in Figure 1. Note:
Typical 3-way wiring is shown. Actual wiring and wire colors
may vary.
Figure 1 - Typical 3-Way Wiring
DIM
. Disconnect the two travel wires, wire connected to common
terminal, and the ground wire.
5. Remove the wall plate from the 3-way wall switch transmitter.
6. Connect the wires of the 3-way wall switch transmitter to the
wires in the junction box as shown in Figure 2. Use the supplied
wire connectors to secure the wires (see Figure 2). Note: Either
black wire on the transmitter can be used to connect to the hot
wire (light) or traveler wire.
7. Connect the green ground wire from transmitter to the ground
wire removed from old switch. Use one of the supplied wire
connectors to secure the wires (see Figure 3).
8. Check wire connections to make sure they are secure and that
no bare wires are exposed.
waRNING: the white neutral wires in a 3-way circuit
must run continuously through the entire circuit. If pres-
ent, do not connect a white neutral wire to either of the
3-way switch wires.
Common Terminal
(Dark Screw)
3-Way Switch
3-Way
Switch
Travel
Wire Travel Wire