Husqvarna 4000 - Manual (Page 15)

15
TECHNICAL SPECIFICATIONS
Weight and Dimensions 4000
Weight – dry 440 lbs 200 kg
Weight with gasoline and oil full 454 lbs 206 kg
Length 61 inch 1549 mm
Width 28 inch 711 mm
Height 38 inch 965 mm
Blade
Material cut Green concrete only
Blade type 13.5” (343 mm) or 12.0” (305 mm) dry cut with tri-arbor
Blade rotation Counter clockwise, upcutting
Blade shaft speed 3500 rpm
Cutting depth 3 inch maximum (76 mm) depending on blade size and
amount of blade wear
Cutting distance from wall 3 1/2 inch 89 mm
Average cutting rate - Estimate only. Speed will vary with job conditions and concrete mixes.
3 inch (76 mm) depth 2 inch (51 mm) depth
Soft aggregates 14 ft/min (4.3 m/min) 24 ft/min (7.3 m/min)
Medium aggregates 11 ft/min (3.4 m/min) 17 ft/min (5.2 m/min)
Hard aggregates 7 ft/min (2.1 m/min) 9 ft/min (2.7 m/mim)
Blades are available in 13.5 inch (343 mm) and 12 inch (305 mm) diameters and in 0.100 inch (2.5 mm),
0.250 inch (6.4 mm), 0.380 inch (9.7 mm), and 0.500 inch (12.7 mm) widths
Engine: Kohler Command Pro CH18S
Engine oil volume 2 quarts 1.9 liters
Gasoline tank volume 4.5 gal 17 liters
Type Air cooled, 4-cycle, twin cylinder, hydraulic overhead
valves, gasoline engine
Air filter Dual element construction duty
Oil system Full pressure lubrication with spin-on oil filter
Muffler Low noise, front exhaust
Emissions Complies with EPA Phase 2 and CARB Tier II USA
regulations
Cooling Air cooled
Cylinder Aluminum with cast iron liner
Controls Engine mounted manual throttle and choke levers,
manual on/off switch
CALIFORNIA AIR RESOURCES BOARD (CARB): This machine is considered a preempt Off-Road
Ap plication as relating to CARB standards. Under construction equipment, and in particular, as a Saws :
concrete, masonry, cutoff, with engine power less than 1 9KW ( 25 hp), CARB standards do not apply to this
machine.
For more information see the website http://www.arb.ca.gov/msprog/offroad/preempt.htm
CONFORMITY CERTIFICATES