Husqvarna 4000 - Manual (Page 2)

CONTENTS
Content Page
Table of contents ………………………….. 2
Unpacking .................................................. 2
Transporting ............................................... 2
Sound Data ................................................ 2
I ntroduction, personal safety ...................... 3
Registration of the product ………………… 4
General safety message ............................ 4
Safety warnings ......................................... 5
Excel series blades ................................... 6
Blade and skid plate installation ................ 6
What is what? ............................................ 7
Operating instructions ............................... 8
Fuel and fuel safety warnings …….…….... 9
Recommended fuels ................................. 9
Recommended oils …….......……….…..… 9
Engine and transmission maintenance ..... 10
Other maintenance ………………….…….. 11
Sawing contraction joints …………....….… 12
Maximizing the Soff-Cut system .......…..... 13
Troubleshooting ......................................... 14
Technical specifications ............................. 15
Conformity certificates ............................... 15
Warranty .................................................... 16
Your 4000 saw has been shipped from the factory thoroughly
inspected. Only minimal assembly is required to start using
the saw. Remove the saw from the container using proper lift-
ing techniques. Discard or recycle the packing material per
your regional laws. In your container will be the 4000 saw,
blade shaft wrench, spark plug wrench, an owner’s manual,
an engine owner’s manual, a part list, a warranty card, a joint
protector sample pack and a ramp for unloading the saw. Con-
nect the battery cables and turn the key switch to the “ON” or
“1” position. Press the rocker switch on the instrument panel
to raise the saw. Place the unloading ramp at the edge of the
container and roll the saw out of the container. Lower the saw
and turn the key switch to the “OFF” or “0” position.
NOTE: No diamond cutting blade or skid plate is included
with the saw. Purchase the appropriate Husqvarna Excel
Series 12 or 13.5 inch blade from your local Husqvarna
Construction Product dealer.
CAUTION
Only use the center hook on the
roll cage when lifting the 4000.
The 4000 saw weights approximately 454 pounds (206 ki-
lograms) when ready to use . Use safe lifting practices when
handling the saw. Always remove the diamond blade when
transporting the saw. Always transport the saw with a skid
plate installed. Fold the guide arm back. The saw can be lifted
from the center hook on the roll cage. Always store and trans-
port the saw in a completely lowered position and secured
from moving.
UNPACKING
2
TRANSPORTING
According to Standard ISO 3744:1998 and Directive 2000/14/
EC for environmental sound level and according to Standard
ISO 11201:1995 for sound level at the operator’s position, the
4000 saw emits the following:
Sound power level Lwa 109 dB (A)
Sound pressure level Lpa 91 dB (A)
SOUND DATA
WARNING
Always wear safety approved hearing protection.
Handle bar
Lifting point
Roll cage
Front guide
Rear guide