Homelite HP35 - Manual (Page 12)

12
099597
Fan Nut
Figure 11 - Removing Fan Nut from Motor Shaft
Figure 10 - Removing Motor and Fan Guard from Heater
Figure 12 - Replacing Motor and Fan Guard into Heater
Fan
1. Remove three screws that
attach fan guard to heater
shell.
2. Remove motor and fan
guard from heater shell
(see Figure 10).
3. Use pliers to remove the
fan nut from front of motor
shaft (see Figure 11).
4a. If replacing fan, remove
old fan and discard. Go to
step 7 below.
4b. If cleaning fan, remove
fan. Be careful not to
damage the fan blade pitch.
5. Clean fan using soft cloth
moistened with kerosene or
solvent.
6. Dry fan thoroughly.
7. Place fan onto motor shaft.
IMPORTANT: When
placing fan onto motor
shaft, make sure part
number stamped on fan is
facing motor.
8. Attach fan nut to end of
motor shaft. Tighten fan
nut firmly.
9. Place motor and fan guard
into rear of heater shell.
Make sure power cord is
properly located (see
Figure 12).
10. Insert three screws through
heater shell and into fan
guard. Tighten screws
firmly.