System setup, 2010 odyssey – HONDA 2010 Odyssey Navigation User Manual
Page 77
![background image](/manuals/93796/77/background.png)
Navigation System
77
System Setup
Setup Mode
The Setup function consists of two
different screens that allow you to
change and update information in the
system. To display the
Setup
screens,
use the voice control system and say
“Setup” or press the
INFO
button and
select
Setup
. To change to another
Setup
screen, say or select
More
in the
upper right corner of the screen.
On any of the
Setup
screens, you can
use the voice control system to select
any item on the screen.
NOTE:
• If some items appear to be grayed out
and cannot be selected, it is because
you did not select
OK
on the initial
Disclaimer
screen. See System Start-
up on page
• For information on the available
voice commands, see Voice
Command Index on page
Setup Screen (first)
From any screen, say “Setup” or press
the
SETUP
button, and the following
screen appears:
Brightness
The screen brightness has 11 settings.
To change the brightness, use the voice
control system and say “Brightness up”
or “Brightness down.” You can also
select the
Bright
. bar and move the
cursor by moving the joystick left or
right, or by touching the arrowheads in
the bar.
Tip:
If you are having trouble viewing the
screen in bright lighting conditions, try
increasing the brightness.
NOTE:
You can have a separate daytime and
nighttime setting for brightness. Adjust
each setting when the display is in either
daytime or nighttime mode.
Volume
The navigation voice volume has 10
settings, and also can be turned off. To
adjust the volume, use the voice control
system and say “Volume up” or
“Volume down.” You can also select the
Volume
bar and move the cursor by
moving the joystick left or right, or by
touching the arrowheads in the bar.
After adjusting the volume, you will
hear beeps at the new volume level. You
can also select volume off.
NOTE:
If you turn the volume off, you will not
hear route guidance or voice command
confirmations.
2010 Odyssey