Hoover Z 400 - Manual (Page 15)

3. Lift out lens.
5. Replace lens by inserting plastic
projections into openings in
cleaner.
The headlight
Disconnect cleaner from electri-
cal outlet.
This cleaner uses two 12 volt,
wedge base type 912 bulbs.
1. Lower the handle until the
cleaner is positioned with the bag
flat on the floor.
2. Use screwdriver to lift lens.
Place screwdriver in the two slots
provided at the top edge under
ridge of lens as shown. Turn
screwdriver to loosen lens.
4. Remove bulbs by pulling
straight out of sockets. Replace
by pushing each bulb straight into
the socket until it locks in place.
(Excessive force is not required.
6. Insert screwdriver into one of
the slots at the top of the head-
light lens. Snap lens into place by
pushing down on handle of
screwdriver while pressing on
lens.
14