Media specifications, Supported sizes of media, Supported – HP 2300dn User Manual

Page 136: Media specifications” on, Media

Advertising
background image

134 A Specifications

ENWW

Media specifications

This printer accepts a variety of media, such as cut-sheet paper (including up to 100 percent
recycled fiber content paper), envelopes, labels, transparencies, and custom-size paper.
Properties such as weight, composition, grain, and moisture content are important factors
affecting printer performance and output quality. Paper that does not meet the guidelines
outlined in this manual can cause the following problems:



poor print quality



increased jams



premature wear on the printer, requiring repair

Note

Some paper might meet all of the guidelines in this manual and still not produce satisfactory
results. This might be the result of improper handling, unacceptable temperature and humidity
levels, or other variables over which Hewlett-Packard has no control.

Before purchasing large quantities of media, make sure that it meets the requirements specified
in this use guide and in the hp LaserJet printer family print media guide (available at

http://www.hp.com/support/ljpaperguide

). Always test paper before buying large quantities.

CAUTION

Using media that does not meet HP specifications can cause problems for the printer, requiring
repair. This repair is not covered by the HP warranty or service agreements.

Supported sizes of media

Note

You might experience some jams when using any media with a length less than
178 mm (7 inches). This can be caused by paper that has been affected by environmental
conditions. For optimum performance, make sure you are storing and handling the media correctly
(see

“Printing and paper storage environment” on page 138

).

Tray 1

Dimensions

1

Weight

Capacity

2

Minimum size
(custom)

76 by 127 mm

(3 by 5 inches)

60 to 163 g/m

2

(16 to 43 lb)

100 sheets of 75 g/m

2

(20 lb) paper

Maximum size
(custom)

216 by 356 mm

(8.5 by 14 inches)

Transparency

Same as minimum and
maximum paper sizes
listed above.

Thickness:
0.10 to 0.14 mm
(0.0039 to 0.0055 inch)

75 typical

Labels

3

Thickness:
0.10 to 0.14 mm

(0.0039 to 0.0055 inch)

50 typical

Envelopes

Up to 90 g/m

2

(16-24 lb)

Up to 10

1.The printer supports a wide range of media sizes. Check the printer software for supported sizes.

See

“Printing on custom-sized media or cardstock” on page 41

.

2.Capacity can vary depending on media weight and thickness, and environmental conditions.
3.Smoothness: 100 to 250 (Sheffield).

Advertising
This manual is related to the following products: