HP 2300dn - Manual (Page 143)

ENWW Media specifications 141
Labels
CAUTION To avoid damaging the printer, use only labels recommended for laser printers
To prevent serious jams, always use tray 1 to print labels and always use the rear output bin.
Never print on the same sheet of labels more than once or print on a partial sheet of labels.
Label construction
When selecting labels, consider the quality of each component:

Adhesives: The adhesive material should be stable at 200° C (392° F), the printer’s fusing
temperature.

Arrangement: Only use labels with no exposed backing between them. Labels can peel off
sheets with spaces between the labels, causing serious jams.

Curl: Prior to printing, labels must lie flat with no more than 13 mm (0.5 in.) of curl in any
direction.

Condition: Do not use labels with wrinkles, bubbles, or other indications of separation.
For more information, see “Printing on labels” on page 39 .
Note Choose labels in the printer driver (see “Printing by type and size of media” on page 53 ).
Transparencies
Transparencies used in the printer must be able to withstand 200° C (392° F), the printer’s fusing
temperature.
CAUTION To avoid damaging the printer, use only transparencies recommended for use in HP LaserJet
printers, such as HP-brand transparencies. (For ordering information, see
“Ordering parts,
accessories, and supplies” on page 116 .)
For more information, see “Printing on transparencies” on page 40 .
Note Choose transparencies in the printer driver (see “Printing by type and size of media” on page 53 ).