Quickspecs – HP Z600 User Manual
Page 18
Memory Configuration
(Supported)
Not all memory configurations possible are represented above.
Only ECC DIMMs are supported.
Do not install memory modules into memory slots if corresponding processor is not
installed.
Dual processor configurations with memory modules installed for only one processor is not
supported.
UDIMM (Unbuffered) and RDIMM (Registered) memory cannot be mixed. All memory
installed in the system must be either UDIMM or RDIMM.
PCI Express
Connectors (Gen2 Rev
0.7 connectors)
2 PCI Express x16 Gen2 graphics
1 PCI Express Gen2 (x8 mechanically, x4 electrically)
1 PCI Express Gen1 (x8 mechanically, x4 electrically)
PCI Connectors (5.0V)
2 full length 33 MHz 32-Bit
Interfaces Supported
SATA
Integrated 6-channel SATA 3.0Gb/sec controller with
RAID 0, 1, 5, 10 and NCQ. (Factory integrated RAID is
Microsoft Windows only)
Serial Attached SCSI
Requires Optional PCIe card
Integrated RAID
Integrated SATA RAID
RAID 0, RAID 1*, RAID 5, RAID 10
Supports one RAID array with 2-4 drives
RAID 0 configuration – striped array (supported and configure to order)
RAID 1 configuration – mirrored array (supported and configure to order)
RAID 5 parity striping (supported but not configure to order)
RAID 10 striped and mirrored array (supported but not configure to order)
NOTES: *HW RAID functionality not supported by Linux. Use SW RAID functionality provided in
the Red Hat Operating system instead.
Integrated Graphics
No
QuickSpecs
HP Z600 Workstation
System Technical Specifications
DA - 13277 Worldwide QuickSpecs — Version 23 — 12/1/2010
Page 18