haier Space Saving 120 Volt Electric Vented Tumble Dryer HLP140E - Manual (Page 20)

Troubleshooting
Symptom
Is the front door closed?
Is Temperature Indicator
LED indicating
'Air Dry'?
Drum won't turn.
(The four indicator
lights of Cycle
button are on at the
same time)
Dryer won't heat.
Reset the
'Temp' button till the
indicator light indicates
'High'
or
'Low', and the LED is on.
The Exhaust Filter is blocked?
Dryer won't work.
No power to machine?
Power plug not in the
socket?
Reduce the amount of garments
loaded in dryer.
Garments were not wringed out
sufficiently by washer spin cycle.
Overloaded dryer with too many
garments ?
Garments won't dry
enough.
Front door not properly shut?
Clothes not sorted to proper cycle
selection?
Close front door and
Press the Start/Pause
button.
Reset circuit breaker or
replace fuses.
Put Power plug in socket.
Close the front door.
Press in the Power/ ON/OFF,
or Start/Pause button.
19
Check your problem by using the chart below (If problems occur, please pull out the plug before examining) and try
the solutions for your problem. If the dryer still does not work properly, contact Haier customer service
center or the nearest authorized service center.
Possible Remedy Possible Cuase
Heating Temperature was not set
for Timed Dry?
Change Temp. settings to
High or Low: Air Dry works
without heat.
Remove and clean Exhaust
vent
Make sure outside vent is not
blocked
Check that Garments are
wringed out sufficiently by
washer spin cycle.
Select the right drying cycle for
normal, heavy or delicate laundry
loads.
Outside venting ducting is blocked?
Never Overload the dryer.
Never put wet clothing that was not wringed out during washer spin cycle.
If you can not find a solution- remove plug from outlet pending resolution.
WARNING
!