Hitachi WR9DM2 - Manual (Page 13)

English
13
Handle
Latch
Recharge-
able
battery
Pull out
Insert
Fig. 3
ASSEMBLY AND OPERATION
APPLICATIONS
<WH12DM2, WH9DM2>
⅜ Driving and removing of small screws, small bolts, etc.
<WR12DM2, WR9DM2>
⅜ Tightening and loosening of all types of bolts and nuts, used for securing structural
items.
REMOVAL AND INSTALLATION METHOD OF BATTERY
⅜ How to install the battery
Align the battery with the groove in tool
handle and slip it into place.
Always insert it all the way until it locks in
place with a little click. If not, it may
accidentally fall out of the tool, causing injury
to you or someone around you. (Fig. 3)
⅜ How to remove the battery
Withdraw battery from the tool handle while
pressing the latch on the side of the battery.
(Fig. 3)
CHARGING METHOD
NOTE: Before plugging into the receptacle, make sure the following points.
⅜ The power source voltage is stated on the nameplate.
⅜ The cord is not damaged.
WARNING:
Do not charge at voltage higher than indicated on the nameplate.
If charged at voltage higher than indicated on the nameplate, the
charger will burn up.
1. Insert the plug of battery charger into the receptacle.
When the plug of battery charger has been inserted into the receptacle, pilot lamp will
blink in red. (At 1-second intervals)
WARNING:
Do not use the electrical cord if damaged. Have it
repaired immediately.
(WH12DM2, WR12DM2)