HP KSC-570 - Manual (Page 29)

24 DIGITAL SATELLITE RECEIVER
Menu Guide
6. 22KHz : Depending on the user’s antenna switch box or LNB.
You can supply either 22KHz by setting “ON” or not
by setting ”OFF”.
When selecting the U-LNB 1 and U-LNB 2,
the 22KHz will be dimmed.
7. 0V/12V : Depending on the user’s antenna switch box.
You can choose either 0V/12V.
8. Tone Burst : Depending on the user’s antenna switch box.
(“off”, “SAT A” or “SAT B”)
9. Press the BLUE button to set Drive(Fine Drive or Normal Drive) to run the motor.
- Fine Drive/Normal Drive : To move the motor, press LEFT/RIGHT( / ) button.
- Go to zero : To move the zero position, press OK( ) button.
- Store to location : To store the current position, press OK( ) button.
- East Limit : To set the east limit by current position, press OK( ) button.
- West Limit : To set the west limit by current position, press OK( ) button.
- Clear Limit : To clear the stored limit value, press OK( ) button.
● After selecting all that is necessary, press RED button to scan the satellite list.
Pop up widow will be displayed.
● Select ON or OFF according to your Network.
● Select All or FTA Search Type.
● Press OK( ) button and searching will start. OK
OK
OK
OK
OK
OK
Channel Search
k1.5 500 SAT(Eng) 1/5/06 5:53 PM ˘ ` 24 mac-4 HP LaserJet 5100 Series T