HP KSC-570 - Manual (Page 32)

27 DIGITAL SATELLITE RECEIVER
Menu Guide
7. 0V/12V : Depending on the user’s antenna switch box.
You can choose either 0V/12V.
8. Tone Burst : Depending on the user’s antenna switch box.
(“off”, “SAT A” or “SAT B”)
9. Longitude : Press the NUMERIC buttons and enter the Longitude.
When the OK( ) button is pressed. It can be toggled
East/West.
10. Latitude : Press the NUMERIC button and enter the Latitude.
When the OK( ) button is pressed, it can be toggled
North/South.
11. Press the BLUE button to set Drive(Fine Drive or Normal Drive) to
run the motor.
- Fine Drive/Normal Drive : To move the motor,
press LEFT/RIGHT( / ) button.
- Go to zero : To move the zero position, press OK( ) button.
- East Limit : To set the east limit by current position, press OK( ) button.
- West Limit : To set the west limit by current position, press OK( ) button.
- Clear Limit : To clear the stored limit value, press OK( ) button.
Note: After the Degree, Longitude and Latitude is enterted accurately.
the DiSEqC Motor will automatically move to the satellite’s position.
● After selecting all that is necessary, press RED button to scan the satellite list.
Pop up widow will be displayed.
● Select ON or OFF according to your Network.
● Select All or FTA Search Type.
● Press OK( ) button and searching will start. OK
OK
OK
OK
OK
OK
OK
Channel Search
k1.5 500 SAT(Eng) 1/5/06 5:53 PM ˘ ` 27 mac-4 HP LaserJet 5100 Series T