Honeywell W8635A User Manual

W8635a equipment interface module, Caution, Application

Advertising
background image

® U.S. Registered Trademark
Copyright © 2000 Honeywell Inc. • • All Rights Reserved

INSTALLATION INSTRUCTIONS

69- 1339- 2

W8635A

Equipment Interface Module

APPLICATION

The W8635A Equipment Interface Module (EIM) pro-
vides 24 Vac control of single or multistage conventional
HVAC equipment when used with a T8635L Microelec-

tronic Communicating Programmable Thermostat. The
W8635A can be used with up to 2 heat/2 cool conven-
tional applications. See Table 1.

Table 1. Description.

INSTALLATION

When Installing this Product…

1.

Read these instructions carefully. Failure to follow
these instructions can damage the product or
cause a hazardous condition.

2.

Check the ratings given in the instructions and on
the product to make sure the product is suitable for
your application.

3.

Installer must be a trained, experienced service
technician.

4.

After completing installation, use these instructions
to check out the product operation.

CAUTION

Voltage Hazard.
Can cause electrical shock or equipment
damage.
Disconnect power before supply before beginning
installation.

Location

CAUTION

Mounting Location Hazard.
Mounting W8635A inside HVAC equipment
can damage the EIM.
Mount the W8635A only on the outside of HVAC
equipment.

1.

Locate the W8635A in the equipment room near
the HVAC equipment. See Fig. 1.

Fig. 1. Selecting W8635A Equipment

Interface Module location.

2.

Remove the cover from the W8635A by pulling on
the edge of the module.

3.

Locate the two mounting holes. See Fig. 2.

Model

Application

Stages

Terminals

Comments

W8635A

Conventional gas, oil
or electric heat

Up to 2 heat/
2 cool

1, 2, 3, C, R, Rh, Rc,
G, W1, W2, Y1, Y2

Use with T8635L Communicating
Thermostat

M16637A

WATER HEATER

W8635
POSSIBLE
MOUNTING
LOCATION

FURNACE OR BOILER

W8635

POSSIBLE

MOUNTING

LOCATION

Advertising