Homelite UT34010 - Manual (Page 14)

14
TO INSTALL BATTERY PACK
See Figure 7.
1. Place the battery pack in your chain saw. Align
raised rib on battery pack with groove in chain
saw’s battery port.
2. Make sure the latches on each side of the battery
pack snap in place and that battery pack is secured
in chain saw before beginning operation.
TO REMOVE BATTERY PACK
See Figure 7.
Locate latches on side of battery pack and depress
both sides to release the battery pack from the chain
saw.
CAUTION:
When placing battery pack in your chain saw, be
sure raised rib on battery pack aligns with
groove in chain saw's battery port and latches
snap in place properly. Improper assembly of
battery pack can cause damage to internal
components.
CAUTION:
Remove battery pack from unit. Fill oil tank with
Homelite Bar and Chain Oil before starting the
chain saw. Failure to lubricate the chain will
cause damage to the bar and chain.
CHAIN OIL SYSTEM
See Figure 8.
1. Use HOMELITE Bar and Chain Oil. It is formulated
to perform over a wide temperature range with no
dilution required.
NOTE: Do not use dirty, used or otherwise con-
taminated oils. Damage may occur to the bar or
chain.
2. Carefully pour the bar and chain oil into the tank.
3. Check and fill the oil tank when battery is re-
charged, or as needed.
4. Depress the oil tank cap several times to pump the
oil to the chain before starting the saw.
5. Depress the oil tank cap every 20-30 seconds while
cutting to keep the chain lubricated.
NOTE: It is normal for oil to seep from the saw when
not in use. To prevent seepage, empty the oil tank after
each use. When storing the unit for a long period of
time (three months or longer) be sure the chain is
lightly lubricated; this will prevent rust on the chain and
bar sprocket.
Fig. 8
Fig. 7
BATTERY
PACK
LATCHES
BATTERY
PORT
OPERATION