Assembly – Husqvarna O0803001 User Manual
Page 8
9
ASSEMBLY
1. Position blower over the discharge tabs on the
deck and set blower onto the deck.
2. Be sure the blower is sitting fl ush against the
outside of the deck.
NOTE: The rear mount bracket is designed to fi t
all deck sizes.
3. Install the front mount bracket to the deck with
the pin and hairpin cotter supplied with the kit.
1. Make sure the tension release lever is forward or
disengaged.
2. Place the belt over the pulley on the deck. Refer
to illustration for proper routing.
3. Move the tension release arm to the rear and
engage in the latch.
3
MOUNTING BLOWER ASSEMBLY
Outer Pulley Cover
Pin
Hairpin Cotter
Rear Mount Bracket
52/61 Contact Area
42/48 Contact Area
52/61 Contact Area
4
INSTALLING DRIVE BELT
Rear Of Deck
Idler Pulleys
Outer Pulley
Twist in Belt
Tension Release Arm