Husqvarna O0803001 - Manual (Page 9)

10
1. Using the hacksaw, trim the belt cover along the
dashed line.
5 TRIMMING BELT COVER
(42" and 48" decks only)
6 INSTALLING BELT COVERS
42/48 Trim Line
1. Place the deck belt shield on the deck over the
drive pulley and secure with hardware removed
from steel belt shield.
2. Place retainer on the outer pulley cover.
3. Align the tab end of the belt cover into the slot on
the deck belt shield and the other end over the
end of the outer pulley cover.
4. Secure with knob.
Retainer
Knob
Outer Pulley Cover
Deck Belt Shield
Belt Cover Tab
Belt Cover
Middle Chute Latch
ASSEMBLY