HONDA 08E55-S01-100H - Manual (Page 5)

© 1999 American Honda Motor Co., Inc - All Rights Reserved. AII 20465 (9908) 5 of 8
Installing the Control Unit
SLOT
13. Route the terminal ends of the disarm switch
harness through the 12 mm hole you just drilled in
the dashboard lower cover. Secure the disarm switch
on the dashboard lower cover using the 12 mm and
washer provided. Tighten the nut securely.
14. Firmly push the terminals of the disarm switch into
the 3-pin connector provided until they click into
position.
15. Pull gently on the wires to verify that they are locked
in the connector. Make sure that the terminals are
positioned properly, then lock the connector.
12 mm NUT
WASHER
PREDRILLED
HOLE
DASHBOARD
LOWER COVER
DISARM SWITCH
Firmly push the terminals into
the connector until they click
into position.
3-PIN
CONNECTOR
BLUE
WIRE
BLACK
WIRE
DISARM
SWITCH
Insert the tabs into the grooves, slide
the lock toward the front, and press
down on the end.
16. Loosen the bolt on the right of the steering shaft,
then slide the slot of the control bracket under the
head of the bolt you just loosened.
CONTROL BRACKET
INTERLOCK
CONTROL UNIT
(A/T Model only)
EXISTING BOLT
(Reuse on A/T
model vehicle.)
6 x 12 mm
FLANGE BOLT
(supplied)
HOLE
CONTROL BRACKET
EXISTING BOLT
(Reuse on A/T
model vehicle.)
17. Align the upper hole in the control unit bracket with
the hole in the dash, and install the 6 x 12 mm
flange bolt supplied. Tighten the 6 x 12 mm bolt, and
the bolt you loosened in step 16 securely.
On A/T model vehicles, attach the control unit
bracket under the interlock control unit, and reuse
the existing bolt.