HONDA 08E55-S01-100H - Manual (Page 7)

© 1999 American Honda Motor Co., Inc - All Rights Reserved. AII 20465 (9908) 7 of 8
WIRE TIES
23. Locate the 4-pin and 6-pin connectors blue-taped to
the vehicle harness behind the fuse box.
24. Locate the 4-pin connector blue-taped to the vehicle
harness above the fuse box, and remove the tape to
free the connector. Plug the 4-pin relay into the 4-pin
connector you just freed, then secure the relay to
the vehicle harness with the wire tie.
25. Locate the 6-pin connector blue-taped to the vehicle
harness above the fuse box, and remove the tape to
free the connector. Remove the short connector from
the 6-pin connector, and plug the 6-pin relay from the
kit into the 6-pin connector. Secure the relay to the
vehicle harness with the wire ties.
BLUE TAPE
VEHICLE
6-PIN
CONNECTOR
SHORT
CONNECTOR
(Discard.)
4-PIN
RELAY
BLUE TAPE
VEHICLE
4-PIN
CONNECTOR
4-PIN AND 6-PIN
CONNECTORS
26. Install the upper steering column cover. Locate
the 2-pin connector blue-taped to the vehicle
harness, and remove the blue tape to free the
connector. Get the resistor supplied with the
attachment kit, plug one end of the resistor into
the 2-pin connector you just freed and the other
end into the 2-pin connector from the LED.
27. Tape the resistor to the vehicle harness using
electrical tape. Secure the LED harness to the
vehicle harness with the three short wire ties in
the areas shown.
28. Install the lower steering column cover. Do not pinch
the LED harness with the cover.
6-PIN
RELAY
SHORT
WIRE TIE
LED 2-PIN
CONNECTOR
2-PIN
CONNECTOR
ELECTRICAL
TAPE
VEHICLE HARNESS
RESISTOR
RESISTOR
BLUE-TAPE
(Remove.)
UPPER STEERING
COLUMN COVER
2-PIN CONNECTOR
SHORT
WIRE
TIE