Using the remote to control vcr functions – Hitachi 50EX01B User Manual
Page 25
25
USING THE REMOTE TO CONTROL VCR FUNCTIONS
Operating the precoded function for your VCR.
This remote is designed to operate different types of VCRs. You must first program the remote to match the remote system of your
VCR. (refer to page 27)
1.
Turn ON your VCR.
2.
Aim the remote control at the front of your VCR.
3.
Press the VCR button to switch to the VCR pre-coded mode.
4.
Hold down the VCR button on the remote, enter the two digit preset code that matches your VCR as shown in page 27. The remote
will turn off your VCR when the correct two digit preset code is entered. When this occurs, the remote control is programmed for
your VCR. If the VCR does not turn off after five seconds, try a different two digit preset code.
5.
The remote will now control your VCR.
*
If you wish to control a DVD player, you must follow the remote
programming procedure shown above. You may use only the
VCR button to program these codes, but note that this button
may not be used for more than one component.
NOTES:
1.
If your VCR cannot be operated after performing the
above procedures, your VCR s code has not been
precoded into the remote.
2.
In the unlikely event that your VCR cannot be operated
after performing the above procedures, please consult
your VCR operating guide.
3.
The remote control will remember the codes you have
programmed until the batteries are removed from the
remote control. After replacing the batteries repeat the
entire programming procedure as stated above.
4.
If your VCR does not have a power function, the remote
will issue the CHANNEL UP function.
5.
The MENU button will act as the VCR MENU button for
HITACHI VCRs.
6.
The LST-CH button will act as your VCR ENTER button if
required.
7.
The SLEEP button will act as your VCR 100 button if
required.
ቢ
VCR Button
This button allows the remote to control your VCR by set-
ting it to VCR mode.
ባ
PRECODED VCR Buttons
These buttons transmit the chosen precoded VCR codes.
For some VCRs, you must press the RECORD button twice
to record a program.
ቤ
EXCLUSIVE TV Buttons
These buttons are for operating the TV.
NOTE:
Refer to instruction manual of the VCR for operation of the buttons exclusively for the VCR.
ቢ
ባ
ቤ
ቤ
ባ
ቤ
ቤ
ባ
CLU-436UI
POWER
TV
CABLE
VCR
HELP
PIP CH
TV/VCR
PIP
SWAP
MOVE
FRZ
REC
STOP
PAUSE
LST-CH
EXIT
RECALL
MUTE
CH
VOL
1
2
3
4
5
6
7
8
9
0
MENU
SLEEP
INPUT
LIGHT