Husqvarna 536 LIL - Manual (Page 13)

ASSEMBLY
English – 13
Fitting the loop handle
• Clip the loop handle onto the shaft. Note that the loop
handle must be fitted between the arrows on the shaft.
• Slide the spacer into the slot in the loop handle.
• Fit the nut, knob and screw. Do not overtighten.
• Now adjust the trimmer to give a comfortable working
position. Tighten the bolt/knob.
Fitting the handlebar
• Position the handlebar as shown. Fit the mounting
components and tighten the knob lightly.
• Put on the harness and hang the machine from the
support hook. Now make a final adjustment so that
the machine is in a comfortable working position when
it hangs from the harness.
• Tighten the knob.
Assembling the guard
• Fit the correct trimmer guard (A) for use with the
trimmer head.
• Hang the trimmer guard on the hook on the plate
holder (1). Bend the guard around the shaft and
tighten it with the bolt (2) on the opposite side of the
shaft.
Adjusting the harness and
trimmer
Li-ion Li-ion
Li-ion Li-ion
!
WARNING! When using a trimmer it must
always be hooked securely to the
harness. Otherwise you will be unable to
control the trimmer safetly and this can
result in injurytp yourselfor others. never
use a harness with a defectivequick
release.
Li-ion Li-ion
1
2
A