HTC SAPPHIRE SM-TP008-1125 - Manual (Page 59)

2/10/2009 9:51:19 PM
HTCUSA-200015
Doc. No. DOC-00051810 REV.
Issued Date 2008/12/29
.
Revised Date 2009/01/14
AX02
Doc. Title Sapphire Service Manual Page 59 of 91
HTC CONFIDENTIAL
SM-TP008-1125
HTC Corporation.
IT IS GENERIC COSMETIC INSPECTION CRITERIA FOR ALL PRODUCTS IF THERE HAVE ANY CONFLICT
WITH THESE GENERIC CRITERIONS; PLEASE FOLLOW THE PRODUCT INSPECTION CRITERIA
RESPECTIVELY.
Description
¾ D: Diameter / L: Length / W: Width / N: Number of defects/ S: Distance from dot to dot
¾ Inspecting distance: 30 ± 5cm / Mechanical inspection angle 90 degrees /
¾ LCM inspection angle 90±15 degrees / Inspection time:5 secs per surface.
¾ Ambient illumination is to be 500-1100 lux
¾ The inspection condition of Newton ring:
a. Inspection distance: 30cm / Inspection time: 5 sec
b. Ambient illumination is to be 500-1000 Lux (Incandescent lamp)
c. Inspection should be performed under the condition that LCD screen could reflect the mirror image of
lamp.
d. The criteria of Newton ring’s tinges and measure of area must follow up the worst-case sample.
5.2 Display inspection
Inspection Defects Accept Level Level
Single Red+ Green+ Blue 3, S > 5mm. Minor
2 adjacent 0 Minor
Bright
Dots
3 or more
adjacent
0 Minor
Single Total Number 2, S > 5mm. Minor
Dark Dots
2 adjacent 0 Minor
Dark or Bright lines 0 Minor
All Allowable Dots DefectsTotal Number 3, S > 5mm. Minor
Electrical Characteristic
Defects
Shift and tilt of screen
viewed area The black edge around display area must
be detected by front view.
Minor
Scratch
0.03 < W 0.1 (mm)
L 5 (mm), N 2 (mm)
Minor
Lint (linear foreign
objects)
0.03 < W 0.1 (mm)
0.3 < L 3.0 (mm)
N 5
Minor
Spots 0.1 < D 0.3 (mm), N 4 Minor
Fish eye on film 0.1 < D 0.4 (mm), N 4 Minor
Breakage on film surface Not acceptable Minor
Foreign Scratch,
Objects or Lint
on power off
status
Total acceptable defect quantity 10 Minor