HTC DS18DMR - Manual (Page 21)

English
21
OPERATION
1. Using the light equipped hook
WARNING:
When using the hook, pay sufficient attention so that the main
equipment does not fall. If the tool falls, there is a risk of accident.
CAUTION:
● Do not attach the tip tool except phillips bit to the tool main unit when carrying the
tool main unit with the hook suspended from a waist belt.
Injury may result if you carry the equipment suspended from the waist belt with sharp
tipped components such as drill bit attached.
1.1 Using the hook
The hook can be installed on the right or left side
and the angle can be adjusted in 5 steps between
0° and 80°.
(1) Operating the hook
(a) Pull out the hook toward you in the direction
of arrow (A) and turn in the direction of arrow
(B). (Fig. 9)
(b) The angle can be adjusted in 5 steps (0°, 20°,
40°, 60°, 80°).
Adjust the angle of the hook to the desired
position for use.
(2) Switching the hook position
CAUTION:
● If the tool falls, there is a risk that malfunction
and/or physical damage can occur. It is
recommended that you also use fall-preventing
wires, etc.
● Incomplete installation of the hook may result in
bodily injury when used.
(a) Securely hold the main unit and remove the
screw using a slotted head screwdriver or a
coin. (Fig. 10)
(b) Remove the hook and spring. (Fig. 11)
(c) Install the hook and spring on the other side
and securely fasten with screw. (Fig. 10)
1
Hook
4
5
2
(A)
(B)
3
Fig. 11
Fig. 9
Fig. 10
Loosen
Spring
Hook
Screw