HTC DS18DMR - Manual (Page 23)

English
23
CAUTION:
● Failure to observe the following can result
in battery leakage, rust or malfunction.
Position the plus (+) and minus (-) terminals
correctly.
Replace both batteries at the same time. Do
not mix old and new batteries.
Remove exhausted batteries from the hook
immediately.
● Do not discard batteries together with
normal trash and do not throw batteries into
fire.
● Store batteries out of the reach of children.
● Use batteries correctly in accordance with
the battery specifications and indications.
2. Using the bit holder
CAUTION:
● Stow the bit in the specified location on the tool. If
the tool is used with the bit stowed improperly,
the bit may fall and cause bodily injury.
● Do not stow bits that are of a different length,
gauge or dimension than the plus driver bit (65 mm
long) included in the STANDARD ACCESSORIES.
The bit may fall and cause bodily injury.
(1) Removing the bit
Securely hold the main unit and pull out the bit by
holding the tip with your thumb. (Fig. 17)
(2) Installing the Bit
Install the bit with steps opposite of when removing.
Insert the bit so that the right and left sides are
equal, as shown in Fig. 18.
3. Installing/Removing the side handle
CAUTION:
● Firmly install the side handle. If loose, the side
handle may gyrate or fall out and cause bodily
injury.
(1) Install the side handle so that the protrusions on
the main unit and grooves on the side handle
interlock. Tighten the grip after checking that the
side handle is not riding on the slip prevention
protrusion. (Fig. 19)
(2) Loosen the grip to remove the side handle.
Fig. 17
Bit
Insert so that
bit does not
protrude
from main
unit
Fig. 18
Fig. 19
Concave
Tighten
Slip preventing
protrusion
Rotate preventing
protrusion
Loosen
Grip
Side
handle
Hook main body
Protu-
berance
Inden-
tation
Fig. 16
AAAA
batteries
Indentation
Protu-
berance
Hook cover