HP 212M - Manual (Page 81)

6-17
Configuring the Switch
SNMP Communities
Config
urin
g the Sw
itch
Figure 6-5. The SNMP Add or Edit Screen
N o t e : In the default configuration, no manager addresses are configured. In this
case, all management stations using the correct community name may access
the switch with the View and Access levels configured for that community. If
you want to limit access to the switch, you can enter up to ten IP addresses
of authorized management stations into the Manager Address field. Entering
the IP addresses in the Manager Address field limits access to only those
addresses.
4. Enter the appropriate value in each of the above fields (use the [Tab] key
to move from one field to the next).
5. Press [Enter], then [S] (for Save) and return to the Switch Management
Access Configuration menu.
If you are adding a
community, the
Community Name field is
blank.
If you are editing an
existing community, the
values for the currently
selected Community
appear in the fields.
Type the value for
this field
Use the Space bar
to select values for
other fields
Sraswb.book : SIER_SW6.FM Page 17 Tuesday, June 30, 1998 12:20 PM