HP 212M - Manual (Page 95)

6-31
Configuring the Switch
Spanning Tree Protocol (STP)
Config
urin
g the Sw
itch
Enabling STP from the Web Browser Interface
This procedure enables or disables STP on the switch.
Figure 6-14. Device Features Screen for Enabling Spanning Tree
3. To enable or disable STP, click on the drop-down
menu, and click on your selection (On or Off).
4. Click on Apply Changes
to activate your choice.
1. Click Here 2. Click Here
Parameter Description
Spanning Tree
(Default: Off) Enables or disables Spanning Tree Protocol across all ports on the
switch. Other STP parameters are available through the console
interface. Enabling or disabling STP through the web browser interface
does not affect the settings of these other parameters. For more
information on STP operation, refer to “How STP Operates” on page page
6-33.
Sraswb.book : SIER_SW6.FM Page 31 Tuesday, June 30, 1998 12:20 PM